Choosing the right Beam for a particular site depends on a number of criteria (which will be discussed in the Blog).
While both types of Beam technology, Reflective and End to End are equally good at detecting smoke, each type has applications to which it is more suitable than the other type.
The sensitivity of all Talentum Flame Detectors is based on the size of the flame and the distance that flame is away from the Flame Detector.
For example, while a Flame Detector will pick up a cigarette lighter flame at 1M, the same size flame would not be detected at a distance of 8M.
There are two types of Fire Panels, Conventional types which have ‘Zones’ which are connected directly to devices such as Optical Beam smoke Detectors or Flame Detectors and Analogue Addressable types which have a loop bus onto which addressable devices can be connected.
Cleaning the Flame Detector, if it is high off the ground, may be difficult and or expensive, this is where the Flame Detector Air Purge kit comes in.
FFE make an Exd End to End Beam Smoke Detector, Fireray 3000 and Exd versions of the Talentum Flame Detector, IR2, IR3 and UV/IR2.
All Exd detectors are designed to be used in what are termed as ‘Hazardous Areas’ (Zone 1) and as such, must be installed as per the guidelines for such areas. Here is some additional information to be aware of when testing FFE Exd Flame Detectors and Beam Smoke Detectors.
Exd Flame Detectors.
The Fireray 3000 is the current FFE End to End Beam smoke detector and has several features which were not found on the previous generation of End to End Beams.
The Fireray 3000 can be aligned by either one or two people using the following described methods:
The internal laser, which is fitted to two of the current beam smoke detectors in the Fireray range is primarily used for alignment. However, it also play's a major role in fault finding.
Once aligned, if the beam smoke detector is not mounted to a solid surface or structure (see other Blogs), it can go out of alignment due to building movement.
All Talentum Flame Detectors have a fast response to Flame, but some are faster than others. These are the reasons why…
To go into a Fire condition, all Talenetum Flame Detectors need is A) an Infra-Red (IR) or IR and Ultra Violet (UV) light source and B) that light source must flicker.
The speed they respond to the light source depends on what type and how many sensors they have fitted.
Spark Detector (Rear Viewing). This Flame Detector only has one IR sensor and so will respond instantaneously to a flickering IR source.
‘Talentum Flame Detectors can see through glass, 4.3µM Types cannot’.
Placing Flame Detectors behind glass either to protect them or for convenience may seem like a good idea. If you have a factory where there is a spray booth for example, you think you may be able to protect the risk by either placing the Flame Detector in an office with the Flame Detector pointing through a window at the risk, or placing it in a glass fronted box in the area to be protected.